06 Å (100), which are similar (2.69 Å (200), 3.09 Å (111), and 1.89 Å (220)) to those reported in the literature [43]. This suggests that this as-deposited Gd2O3 film is polycrystalline. The energy diffraction X-ray spectroscopy (EDX) Bafilomycin A1 mouse spectra confirm the presence of expected elements Ir, Gd, W, and O in respective layers, as shown in Figure 4b. The X-ray photoelectron spectroscopy (XPS) spectra of Gd 3d 5/2 and Gd2O3 3d 5/2 peaks are located at 1,186.73 and 1,189 eV, respectively (Figure 5), which proves a Gd-rich Gd2O3 film, i.e., GdO x . The height ratio of

Gd/Gd2O3 is 1:0.93, and area ratio of Gd/Gd2O3 is 1:0.89. Arhen et al. [44] reported the same chemical bonding states at 1,186 Selleck CDK inhibitor and 1,188 eV for the Gd 3d 5/2 and Gd2O3 3d 5/2 peaks, respectively. This suggests that the as-deposited Gd2O3 film is a Gd-rich GdO x film. It is known that the grain boundary has more defects or weak Gd-O bonds. This suggests that the Gd-O bonds will break easily under external bias, and more oxygen vacancies will be created. The conducting filament will be formed through the grain boundaries. However, the nanotips on the W BE will help the structure have repeatable resistive switching memory characteristics. Figure 4 TEM image and EDX spectra. (a) Cross-sectional buy GS-7977 TEM image of IrO x /GdO x /W structure. Polycrystalline GdO x film is observed.

(b) EDX spectra show the Ir, Gd, W, and O elements. Figure 5 XPS characteristics of the Gd 2 O 3 films. XPS spectra of the Gd 3d and Gd2O3 3d core-level electrons. Figure 6a shows the typical current–voltage (I-V) characteristics of a IrO x /GdO x /W RRAM device in via-hole structure, as illustrated schematically in Figure 3. The pristine device shows very low leakage current (arrow 1). In order to activate Montelukast Sodium the resistive switching, an initial soft breakdown process (forming) was carried out by applying negative bias on the TE. The negative forming

voltage (V form) is -6.4 V to initiate the resistive switching with a current compliance (CC) of 100 μA. During the formation process, the Gd-O bonds break, which creates oxygen vacancy as well as oxygen vacancy filament, and set LRS. In consequence, the oxygen ions (O2–) will be migrated toward the W BE and react partially at the BE. Bipolar I-V characteristics are indicated by arrows 2 to 4. The SET (V SET) and RESET voltages (V RESET) are found to be -2.2 and +2 V, respectively. To elucidate the conduction mechanism of the IrO x /GdO x /W memory device, the I-V curves are plotted in log-log scale, as shown in Figure 6b. Both LRS and HRS show ohmic conduction behaviors with a slope approximately 1.1. The LRS is ohmic because of the conducting filament formation in the GdO x layer. The HRS is also ohmic because the electrons move through the defects of the GdO x grain boundary. The ohmic behavior of the HRS was also reported by Jung et al. [45]. The resistive switching mechanism can be explained as follows.