Velaglucerase alfa and imiglucerase, both biotinylated and non-biotinylated (analytes) were serially diluted in 1× HBS-EP to obtain concentrations learn more of 0.31, 0.625, 1.25, 2.5, 5, and 10 nM, and injected at a flow rate of 50 μL/min with a contact time of 300 s and a dissociation time of 500–1000 s. After each cycle, the CM5 sensor chip was regenerated with 100 mM phosphoric acid, pH 2.0 at a flow rate of 60 μL/min with a contact time of 120 s. The sensorgrams were evaluated using Biacore™ T100 Evaluation Software with local Rmax fitting to a 1:1 binding model. Following the highly sensitive screening stage, a specific confirmatory assay was required to eliminate false-positives
from the screening results. The assay used was isotype-specific for IgG anti-drug antibody. The method described was identical for imiglucerase
antibodies, substituting imiglucerase for velaglucerase alfa wherever written. The assay was performed in solution phase in microdilution tubes positioned in an 8 × 12 tube rack, placed within a shielded box consisting of either leaded Plexiglas or lead foil. 100 μL of samples and controls was added to each tube, followed by 20 μL of 125I-velaglucerase alfa working solution. The working solution of 125I-velaglucerase Natural Product Library mw alfa was adjusted to 250,000 ± 8000 counts per minute (CPM) per 20 μL using dilution with RIP binding buffer (20 mM NaPO4 pH 7.0, 100 mM NaCl, 0.05% Acyl CoA dehydrogenase polyoxyethylene 20-sorbitan monolaurate). Each tube was mixed briefly, and incubated at room temperature for 2 h to allow IgG antibodies present to form antigen/antibody complexes. After 2 h, 120 μL of each sample was loaded into a separate Protein G column, assembled in a VersaPlate manifold connected to a vacuum pump, and incubated at room temperature for 20 min. The columns were washed five times with 1 mL of RIP binding buffer per wash. After the last wash, vacuum strength was increased to the maximum level for 2 min to remove all RIP binding buffer from the columns. To quantify the immune complex, each individual column was placed in
a separate gamma counter tube and counted using the appropriate settings for 125I for 1 min, and the mean, standard deviation, and percent relative standard deviation (% RSD) of the replicates for all samples, calibration curve points, controls and blank were calculated. The radioactive counts that retained in the mini-column were proportional to the concentration of anti-velaglucerase alfa IgG antibodies in the test sample. The concentration of anti-velaglucerase alfa IgG antibodies in test samples was estimated from a calibration curve using the same mouse anti-glucocerebrosidase monoclonal antibody calibrator discussed above. Serum samples for testing were diluted in RIP binding buffer, to a minimum dilution of 1/20.